Picoboot Flex Cable For Gamecube DOL-001 Raspberry Pi Pico Board With GC2SD/SD2SP2 Pro Adapter For NGC Game Accessories

Attention:

Precautions for welding FPC soft cables to help you complete the operation safer and more efficiently:

1. Temperature and tool selection

Temperature control: The FPC soft cable material is fragile. It is recommended to set the soldering iron temperature to 280-320°C (lower than the normal temperature), and use a constant temperature soldering iron first.

Soldering iron tip selection: Use a pointed or cutter tip soldering iron (such as a 0.5mm tip) to reduce the contact area and avoid excessive heat conduction.

Anti-static measures: Wear an anti-static bracelet before welding to prevent electrostatic breakdown of components on the FPC.

2. Use of flux

Pre-applying a small amount of flux (such as rosin or no-clean type) on FPC pads and device pads reduces the risk of oxidation and improves solder fluidity.

Avoid using highly corrosive acid fluxes.

3. Solder application techniques

Small amount of solder: Just apply a thin layer of solder to the FPC pad or gold fingers. Too much can lead to short circuits or bloated solder joints.

Solder wire selection: Recommended lead-containing solder (such as Sn63/Pb37) or low-temperature lead-free solder (such as Sn-Bi), with low melting point and good fluidity.

Introduction:

"Picoboot FPC Flex Cable can replace traditional wire soldering solutions, greatly reducing the difficulty of soldering. It is fully compatible with the console's mainboard and casing, allowing for non-destructive installation, while also avoiding communication interference that can cause the console to fail to start."

NOTE

Welding this product requires some welding skills, please do not try easily, if you have any questions, please contact customer service in time!

Features:

•Easy installation, No additional cables required
•Compatible with NGC DOL-001 models only.
•High-quality flexible cable, anti-pressure and anti-bending
•Immersion gold solder joints,Stable data transmission

Product Detail

SD2SP2 Pro Adapter

It's a SD card adapter. Player can play games in the SD card via Swiss.

The adapter bypasses the limitations of GameCube memory card adapters and allows the use of memory cards larger than 2GB. The maximum capacity of memory card that can be used is dictated by the software being used, currently this is up to 512GB for Swiss, but note that only some memory cards are compatible with Swiss and you should check online to ensure your memory card will work.

Attention:

1.Before purchasing please ensure your GameCube consolehas a Serial Port 2 port and that you are able to launch Swiss. (Make sure that XENO Modchip had been installed in your console.)

2.If you need Swiss Boot Disc Mini DVD with the SD2SP2, please click the link below.
https://www.Uellow.us/item/3256805501420858.html

Features:

- Serial port SD memory card adapter for running homebrew software on a GameCube console.

- Easy to plug and play your SD card.

Introduction:

Brand New High quality original GC2SD Adapter. Runs on any version of the Gamecube and Wii console. Mainly used to store game files, easy to use without complex operation.

Features:

- Supports most GameCube & Wii consoles.

- Supports micro sd card ：1GB ~ 512GB.

- Backup game files and run homebrew applications.